User's Manual

AP_CMM2 User Manual Issue 4 Draft Pa

e 17 of 48

Single Access Point Module

A single Access Point module can use any of the frequency channels that are available.

Single Access Point Cluster

Use the following table as a recommendation to assign frequency channels and sector IDs (see

section on Configuration interface screen for information on sector IDs). Each frequency is reused

on the sector that is at a 180-degree offset. Symbol refers to the layout in the diagram below

(Figure 6).

2.4 GHz Plan

Direction of Access Point

sector

Frequency Sector ID Symbol

North – (0°) 2.415 GHz 0 A

Northeast – (60°) 2.435 GHz 1 B

Southeast – (120°) 2.4575 GHz 2 C

South – (180°) 2.415 GHz 3 A

Southwest – (240°) 2.435 GHz 4 B

Northwest – (300°) 2.4575 GHz 5 C

5.2 GHz Plan

Direction of Access Point sector Frequency Sector ID Symbol

North – (0°) 5.275 GHz 0 A

Northeast – (60°) 5.300 GHz 1 B

Southeast – (120°) 5.325 GHz 2 C

South – (180°) 5.275 GHz 3 A

Southwest – (240°) 5.300 GHz 4 B

Northwest – (300°) 5.325 GHz 5 C

5.7 GHz Plan

Direction of Access Point sector Frequency Sector ID Symbol

North – (0°) 5.735 GHz 0 A

Northeast – (60°) 5.755 GHz 1 B

Southeast – (120°) 5.775 GHz 2 C

South – (180°) 5.735 GHz 3 A

Southwest – (240°) 5.755 GHz 4 B

Northwest – (300°) 5.775 GHz 5 C

Multiple Access Points Clusters

When deploying multiple Access Point cluster in a given area it is recommended that the clusters

be aligned in the following manner.