User's Manual

SPECIFICATIONS
Operating
Frequency Range
2.4 Modules: ISM 2.4 to 2.4835 GHz
5.2 Modules: U-NII: 5.25 to 5.35 GHz
5.7 Modules: ISM: 5.725 to 5.850 GHz
Access Method Time Division Multiple Access (TDMA)
Signaling Rate 10 Mbps or 20 Mbps
Modulation Type High Index 2-level or 4-level Frequency Shift Keying (FSK)
(Optimized for interference rejection)
Carrier to
Interference (C/I)
3 dB nominal for 10 Mbps, 10 dB nominal for 20 Mbps
Receiver
Sensitivity
-83 dBm 10
-4
BER for 10 Mbps, -79 dBm 10
-4
BER for 20 Mbps
Operating Range
(All Weather)
Up to 35 miles (56 km) with passive reflectors in the 2.4 GHz band. Up to 2
miles (3.6 km) with integrated antenna in the 5.2 GHz band. Up to 35 miles
(56 km) with passive reflector in the 5.7 GHz band.
Transmitter Power Meets FCC U-NII/ISM and IC LELAN ERP Limit
DC Power
measured at DC
converter
0.34 A @ 24 VDC (8.2 watts) typical
0.38 A @ 24 VDC (9.1 watts) max (long cable runs, high ambient
temperature, high transmit ratio (set by downlink percentage))
Interface 10/100 BaseT, half/full duplex
Rate auto negotiated (802.3 compliant)
Protocols Used by
Canopy
IPV4, UDP, TCP, ICMP, Telnet,
HTTP, FTP, SNMP, DES
Protocols
Supported by
Canopy
Switched Layer 2 Transport with support for all common Ethernet protocols
including IPV6, NetBIOS, DHCP, IPX, etc.
Software Upgrade
Path
Remotely downloaded into FLASH via RF link
Network
Management
HTTP, TELNET, FTP, SNMP
Temperature
-40°C to +55°C (-40ºF - +131ºF)