User's Manual

Backhaul User Manual Issue 4 Draft Pa
g
e 11 of 55
Eth erne t
Cable
Base Cover
Rel e ase
Lever
Base Cover
FIGURE 1
Remove the base cover as shown in FIGURE 1 to access the Ethernet connection and the
Connection LED alignment indicators.
♦ The RJ-45 connector is used to attach the Ethernet cable
♦ The RJ-11 connector is used to attach the GPS sync cable
♦ The LED’s indicate system status and are used for alignment.
Etherne t
Cabl e
Canopy B
H
RJ 4 5
Conne c t or
Conne c tion
LE D s
Base Cover
RJ 1 1
Conne c t or
FIGURE 2
The diagnostic LEDs report information about the current status of the access point module. The
following descriptions explain the function of each LED.
Operational Mode
LNK: The link LED displays the status of the Ethernet link to the Canopy module. The LED will be
constantly lit if there is an Ethernet link present. The LED is colored green.
ACT/4: The activity LED displays the status of any data activity on the Ethernet link. The LED will
flash (at no particular speed) when data is being transferred on the Ethernet link. The LED is