User's Manual Part 2

Installing the Simulcast Remote Site Router Chapter 5: Installing the Digital Simulcast Remote Site (10Base-2)
Figure 5-21 Rear View of the Simulcast Remote Site Router
Installing the Simulcast Remote Site Router
This section describes how to install the simulcast remote site router.
Grounding the Chassis
Some network topologies require a grounding stud, which is separate from the AC ground
on the chassis of the networking equipment. If this type of grounding is required for the
topology, perform Procedure 5-6 to connect the chassis ground.
Procedure 5-6 How to Connect a Chassis Ground
1 Terminate o
ne end of a length of minimum 6 AWG wire with a compression lug.
2
Using a grounding screw, attach the lug to the rear of the chassis.
3
Terminate the other end of the wire on a permanently connected protective grounding conductor
or RGB.
Wiring for Power
Power is provided to the simulcast remote site router by connecting a power cable to
the power receptacle on the rear of the unit.
Cabling the Simulcast Remote Site Router
Table 5-31 lists the cable connections from the simulcast remote site router.
5-44 68P81003Y71-O November 2002