User's Manual Part 1

Simulcast Hardware Installation Mechanical Installation Guidelines
Mechanical Installation Guidelines



Hardware components are typically installed into a equipment cabinet or a standard
48.26 cm (19-in) rack. This section provides the following descriptions and guidelines
for performing an install with the equipment cabinet:
• "Description of an Equipment Rack" on page 1-3
• "Installing Equipment in the Equipment Cabinet or Rack" on page 1-6
Description of an Equipment Rack
Figure 1-1 shows the front view of the equipment rack and identifies mounting locations for installing
components. The cage nut and slide rail location numbers are determined by counting the blank hole
locations (starting from the rack bottom). The callouts represent the hole numbers.
68P81003Y71-O November 2002 1-3