User's Manual

4 68P80801E35-B 5/1/2002

Base Radio EBTS System Manual - Vol 2

Generation 2 Single Channel 800 MHz Base Radio Overview

Generation 2 Single Channel Radio Controls and Indicators

The Power Supply and EBRC contain controls and indicators that provide a

means for monitoring various status and operating conditions of the BR, and also

aid in fault isolation. The controls and indicators for both modules are discussed

in the Power Supply and EBRC sections of this chapter.

The Power Supply contains two front panel indicators; the EBRC contains eight

front panel indicators. The Power Supply contains a power switch used to apply

power to the BR. The EBRC contains a RESET switch used to reset the BR.

Generation 2/EBRC Compatibility

The Enhanced Base Radio Controller (EBRC) serves as the main controller for the

Base Radio. The EBRC provides signal processing and operational control for

other Base Radio modules. Figure 1 shows a top view of the EBRC module with

the cover removed. The EBRC module consists of two printed circuit boards

(EBRC board and LED display board), a slide-in housing, and associated

hardware.

❐ The EBRC is only compatible with System Software Release SR 9.15 or later.

Any system running a pre-SR 9.15 System Release must be updated to at

least SR 9.15 prior to installation.

❐ The EBRC module is compatible with Legacy Base Radios that support

multiple receiver module assemblies.

❐ The Generation 2 Base Radio is compatible with all versions of power

supplies.

Table 2 EBRC Compatibility

Module Software Revision System Release

Exciter R01.00.xx- R01.03.xx SR10.0 or Greater

Exciter R01.04.xx and higher SR9.15 or Greater

Single Receiver R01.00.xx - R01.02.xx SR10.0 or Greater

Single Receiver R01.03.xx and higher SR9.15 or Greater

3X Receiver all versions SR9.15 or Greater

40W Power Ampliﬁer all versions SR9.15 or Greater

70W Power Ampliﬁer all versions SR9.15 or Greater