User's Manual

9-4 MTR2000 MOTOTRBO Digital Upgrade: Unpacking
Figure 9-3. Removing two screws securing the Transceiver Assembly
4. Remove the Wireline and Auxiliary I/O Card(s) (if any are installed) as the card(s) will not be
supported in an upgraded MTR2000.
5. Secure the new Station Control Module (SCM), Exciter and Receiver Modules using the eight
screws (Refer to Figure 9-4) supplied with the MTR2000 MOTOTRBO Digital Upgrade kit to
form the new Transceiver Assembly.
Figure 9-4. Putting together new SCM, Exciter and Receiver
6. Slide the new Transceiver Assembly into the MTR2000 station (along the guide rails) to mate
with the connector on the backplane.
Applicant: Motorola
Equipment Type: ABZ89FC4829
Exhibit D1-4