User's Manual

MTR2000 MOTOTRBO Digital Upgrade: Unpacking 9-3
9.2.1.3 Analog to Digital Migration Path – Removal and Replacement
1. Remove the MTR2000 station front bezel from its chassis locking clip by carefully pulling the
bezel forward (Refer to Figure 9-1).
Figure 9-1. Removing Front Bezel
2. Disconnect the Exciter-to-PA Coaxial Cable and Rx Input Cable (Refer to Figure 9-2). By
disconnecting the cables, the Exciter Module, Receiver Module, Station Control Module
(SCM) are accessible.
Figure 9-2. Removing RF cable
3. Remove the two screws securing the Transceiver (SCM, Exciter, and Receiver modules) to
the bottom plate. Pull forward on the cast knobs, carefully slide the assembly out of the
station (Refer to Figure 9-3) and place it aside.
Cast knob
Chassis locking clip
Applicant: Motorola
Equipment Type: ABZ89FC4827
Exhibit D1-4