User's Manual

D R A F T – 9/10/2001
Configuration
Device type The second line should read Subscriber Modem – Multipoint
Mode. Any other label indicates an inappropriate
preconfiguration of the WHiSP radio
RF Frequency
Scan List
Check only RF Frequencies as instructed by your Wireless
Internet Service Provider (ISP). Only check “None” should
you be instructed by your service provider’s technical support.
Lan1 IP is preconfigured to the address 192.168.100.1 for all subscriber
modems. Change this only at the instruction of your service
provider’s technical support.
Lan1 Subnet Mask is preconfigured to the value 255.255.255.0 for all subscriber
modems. Change this only at the instruction of your service
provider’s technical support.
Default Gateway is preconfigured to the address 192.168.100.0 for all subscriber
modems. Change this only at the instruction of your service
provider’s technical support. This may be password protected.
Provider ID is the time set by the wireless service provider
Update Flash overwrites configuration previously saved to the WHiSP radio.
Changes will not take effect until the radio is power-cycled or
rebooted.
Reboot Initiates a radio reboot.
Data Slots Down This information is for use of technical support
Clear Changes Re-displays current configuration of WHiSP configuration.