User's Manual

D R A F T – 9/10/2001
Status
Device type should read Subscriber Modem – Multipoint Mode. Any
other label indicates an inappropriate preconfiguration of the
WHiSP radio
Software Version should be noted in the event you have technical difficulties and
need to contact technical support
FPGA Version should be noted in the event you have technical difficulties and
need to contact technical support
Device ESN is the Link Layer Ethernet Address assigned to your WHiSP
radio. Every WHiSP radio, Ethernet card, or Network
Interface Card (NIC) will have a unique number preconfigured
Uptime is the length of time your WHiSP radio has been operating
since power was last applied
System Time is the time set by the wireless service provider
Session Status Scanning/Registering/Registered/Aiming
This information is for use of technical support
Data Slots Up This information is for use of technical support
Data Slots Down This information is for use of technical support
Air Delay This information is for use of technical support
RSSI This information is for use of technical support
Jitter This information is for use of technical support
Ethernet Interface 10/100 Base T, either half or full Duplex
This information is for use of technical support