User's Manual

64
Utility Software
Card Settings
Sound/Other Settings
• Insert the FOMA terminal into the PC card slot before
performing these steps.
• While the Sound/Other Setting screen is displayed, no
operations can be performed on the Main screen. If a call
arrives during the operation, the call can be answered by
clicking [キャンセル (Cancel)], however, the options being
set will be canceled.
Sound Settings
Setting a Ring Tone and Earphone
Volume
a
Click (各種設定 (Settings)) on the
Main screen (P54)y“カード設定 (Card
Settings)”y“音の設定 (Sound Settings)”
tab
b
Perform the following steps
Using the PC Speaker for Incoming Calls (Ring tone)
yClick the check box
•[再生 (Play)] / [停止 (Stop)] : You can try the ring tone.
Earpiece volume
You can adjust the earpiece volume during a call in eight levels
from “小 (Low)” to “大 (High)”.
yDrag the slide right or left.
Earphone ring tone volume
You can adjust the earphone ring tone volume for an incoming
call in eight levels from “小 (Low)” to “大 (High)”.
yDrag the slide right or left.
c
Click [OK]/[適用 (Apply)]
• Adjust ring volume from the PC using the volume control
of the PC.
Other Settings
Setting Other Options
You can set whether to send Caller ID, turn on/
off the status lamp or whether to display the
Main screen at start-up.
a
Click (各種設定 (Settings)) on the
Main screen (P54)y“カード設定 (Card
Settings)”y“その他の設定 (Other
Settings)” tab
Default
着信音 (Ring tone):
イヤホン受信音量 (Earpiece volume): 4
イヤホン着信音量 (Earphone ring tone volume)
: 4
: The ring tone does not sound from the PC speakers.
: The ring tone sounds from the PC speakers.
Sound Setting Screen
Default
ユーティリティ起動時にメイン画面を表示する
(Display the Main screen when launching the
utility software):
メイン画面を常に手前に表示する (Display the
Main screen always on top):
着信時にメイン画面を手前に表示する (The Main
screen opens on top at start-up):
番号通知 (Caller ID): 通知 (Notify)
(LED) 点灯消灯切替 (Turn on/off the LED): ON
コンピュータの電源OFFスタンバイ移行時に音
声電話を切断する (Disconnect a voice call
when shutting down the PC/moving to
standby mode):
Other Settings Screen
Card Settings