User's Manual

63
Utility Software
Security Settings
Setting UIM PIN
You can set the PIN1 code for the UIM.
• Insert the FOMA terminal into the PC card slot before
performing these steps.
• While the Security Settings screen is displayed, no
operations can be performed from the Main screen. If a call
arrives during the operation, the call can be answered after
[閉じる (Close)] is clicked, however, the options being set
will be canceled.
Entering a PIN1 Code/Changing the
PIN1 Code
You can require the PIN1 code entry each time
the M2501 HIGH-SPEED Utility is launched. You
can also change the PIN1 code.
a
Click (各種設定 (Settings)) on the
Main screen (P54)y“セキュリティ設定
(Security Settings)”
b
Perform the following steps
PIN Verification at Start-up
You can set to require the PIN1 code to use the utility software.
yPull down menuy“有 (Yes)”/“無 (No)”y[設定 (Set)]yEnter
the PIN (4 - 8 digits)yClick [照合 (Verify)]
• Enter the PIN1 code using the keyboard of the PC.
Changing the PIN
You can change the PIN1 code. Set “起動時PIN1コード照合
(Verification at Start up)” to “有り (Yes)” before performing
steps.
y[変更 (Change)]yEnter the current PIN1 code (4 - 8 digits)
yEnter the new PIN1 code (4 - 8 digits)yEnter the new PIN1
again for verificationyClick [変更 (Change)]
• Enter the PIN1 code using the keyboard of the PC.
• The PIN1 code is set to “0000” by default. However, if
you are using a UIM that has been changed from the
default, the PIN1 code remains the same as set
previously.
• If an incorrect PIN1 code is entered three times in a row,
the PIN is locked automatically. Write down the PIN and
keep it in a safe place.
• If you intend to perform packet communication or 64K
data communication, set “起動時PINコード照合 (PIN1
Code Verification at Start up)” to “(無) No”.
• The PIN1 code is stored on the UIM.
Unlocking a Locked PIN
If an incorrect PIN1 code is entered three times
in a row on the screen requiring the PIN1 code
entry, the PIN1 code is locked. If this happens,
you need to unlock the PIN1 code and set a new
PIN1 code.
a
Enter the PUK code (8 digits)
• Enter the PUK code using the keyboard of the PC.
• For the PUK code, refer to your original FOMA
subscription form (customer’s copy).
b
Enter the new PIN1 code (4 - 8 digits)
• Enter the PIN using the keyboard of the PC.
c
Enter the new PIN1 code againyClick [解
除 (Unlock)]
• If an incorrect PUK code is entered ten times in a row,
the PUK code is locked automatically. Write down the
code and keep it in a safe place.
• If you do not have the PUK code or the code is
completely locked, you need to bring the FOMA HIGH-
SPEED terminal, the UIM, and an ID (driver’s license,
etc.) to a DoCoMo shop.
Default
起動時PINコード照合 (PIN Code Verification at
Start-up): 無 (No)
Security Setting Screen
Security Settings