User's Manual

17
Before Using the FOMA Terminal UIM (FOMA Card)
Lamp
aMode Lamp
*: Approximate flashing times in about two seconds
bAntenna Lamp
UIM (FOMA Card)
The UIM is an IC card that stores personal
information such as your phone number.
Without the UIM inserted in the FOMA terminal,
you cannot make voice calls, video calls or data
communications.
For details on the UIM, refer to the instruction
manual for the UIM.
Inserting/Removing the UIM
Inserting
a
Insert the UIM in the direction shown
below into the card slot on the back of
the FOMA terminal
b
Insert the UIM until the release lever
slides in place
• Push the terminal in until the release lever reaches the
above position.
FOMA Terminal Status Mode Lamp
Power off/Standby Off
Waiting to connect to the FOMA
network
Lights green
Packet
communication
Sending or
receiving
Flashes orange
Communicating Lights orange
64K data
communication
Sending or
receiving
Flashes green
Voice/video call
Outgoing or
incoming
64K data
communication
Communicating
Lights green
Voice/video call During a call
Multiaccess
Sending or
receiving/Outgoing
or incoming
Flashes orange/
green (4 times*)
Communicating/
Calling
Flashes orange/
green (1 time*)
FOMA Terminal Status Antenna Lamp
Power off Off
Waiting to connect to the FOMA
network
Lights green
Signal
reception
level
Three bars Lights green
Two bars Flashes green
One bar Flashes orange
圏外 (Out of the service
area)
Lights red
ANT
MODE
a
b
The FOMA HIGH-SPEED terminal
failed
Lights red
An invalid UIM is inserted
UIM not inserted/not recognized
A PIN Code/PUK Code must be
entered
The PIN code block is on
FOMA Terminal Status Antenna Lamp
IC
Notch
Hold the card with the
gold color IC portion
side down
Release Lever