Service manual

1.Introduction
In order to support the TaiChi phone rollout in the Chinese market we need to develop
the charger base/docking station for the phone. The charger base will have data
passthrough functionality to support the integrated mobile organizer in the phone, as
well as use the existing Kramer Rapid Travel Charger. The new charger must provide
the following capabilities:
• Charge the single TaiChi battery (standard Zap LSQ8) in the phone.
• Charge a spare battery in the rear pocket (standard Zap LSQ8 only).
• Hold phone in front pocket, and main battery in the rear pocket at the
same time.
• Be compatible with the Kramer Rapid Travel Charger: SPN4654A
• Capable of charging Nickel Metal Hydride or Lithium Ion batteries.
• Provide LED readout’s as to the charging status of the batteries, and
indicate data transfer.
• Phone flip must be able to open while charging.
• Have TrueSynch data transfer capability via the data cable, which will
use the Hirose Startac connector on the back of the unit.
2.Product Description
2.1 Part Numbers & Physical Characteristics
Part Numbers
SPN4801A A6188 Dual Pocket Desktop Charger Base (PRC label
version)
SPN4654A Rapid Travel Charger (PRC version)
SKN6133A Sync cable
2.2 Physical Characteristics
2.2A Top Housing
• Top Housing will be designed to accept the A6188 phone in the front
facing upright position.
• Gray textured plastic.
• Motorola logo with “Motorola” on top housing.
2.2B Bottom Housing
• The bottom housing will use the Hirose female connector to accommodate
the data cable. If desired the travel charger can be plugged directly into the
charger unit, but data functionality will not be available in this
configuration.
• Rubber Friction feet on front two corners of bottom housing