Service manual

10. Assembly and Disassembly
10. 1 Introduction
In order to perform thorough disassembly,before the phone disassembly, the antenna must be
removed first.
Reasonable care should be taken in order to avoid damaging or stressing the housing
and internal components. Motorola recommends the use of a properly grounded high
impedance conductive wrist strap while performing any of these procedures.
CAUTION
10. 2 Tools
Recommended Tools
The following tools are recommended for use during the disassembly and reassembly
of the phone:
•Anti-Static Tools( 01-80386A82)
includes:
—Anti_Static Mat( 66-80387A95)
—Ground Cord( 66-80334B36)
—Wrist Band( 42-80385A59)
•Dental Tool
•Plastic prying Tool( SLN7223A)
•Torx Hexangular Screwdriver
10. 3 Disassembly
Disassembly Produce
The following steps describe the produce for removing each part of the phone.
NOTE
10. 4 Assembly
Assembly Procedure
Once the unit is disassembled and the repair is carried out it then becomes obvious
that to assemble the unit, the assembly procedure is the reverse of that previously
completed for disassembly.
Back Housing Disassembly
Step 1
Many of the integrated circuit devices used in this equipment are vulnerable to
damage from static charges. For sure to use anti-statc handling procedures during
the operation, transportation, and maintenace of the integrated parts of the phone.
During the procedure of disassembly or assembly , see to the ‘Phone Schematc
Diagram’ if necessary.