Service manual

Step 12: When the third block of data has been transferred
successfully,remobe the Transfer card and check the repaired radio
functions correctly.See to the information in ‘Testing’.
8. 3 Master Transfer
This method of transfer should only be followed when the defective unit will
not power up, or complete a Normal Transfer. As mentioned earlier, there are
different variations (OEM looks) of the Motorola cellular telephones, each
model requiring the main board to be configured differently for correct
operation. When carrying out a Master Transfer it is not possible to transfer
the customers selected features or stored phone numbers, only the
personality can be programmed into the repaired unit.
Each different version of the cellular telephone, has its own Master card which
contains essential set up information. Master SIM cards may be ordered
preprogrammed, or created from a Normal Transfer card. The instruction
steps should be followed in order.
Step 1: Select the required Master SIM card.
Step 2: Insert the Master Transfer card into the slot located on the back of the
repaired unit.Turn the donor unit on, the display should show‘Clone’.
Step 3: Enter 04# via the units keypad.This command will cause the
configuration data to be downloaded from the Master Transfer card.
Step 4: While data transfer is taking place between the card and the unit,
‘Please wait’ will be displayed. After a short period of time, if the data transfer
has been completed correctly, ‘Clone’will re-appear in the recipient units
display.
Step 5: When the third block of data has been transferred
successfully,remobe the Master Transfer card and check the repaired radio
functions correctly.See to the information in ‘Testing’.
At no point should either 021# or 022# be entered while a Master Transfer
card is in the radio. If either of the stated commands is entered, the master
information on the card will be erased. To prevent the above happening the
card can be locked by entering 06# via the units keypads, with the card
inserted. Unlocked the card by entering 07# .
·If during either transfer process a problem arises, an error message will be
displayed. If the Transfer card is removed before the data transfer is
completed ‘Bad Data on Card’ will appear in the display. If either situation
arises, the process should be repeated.
8. 4 Master SIM Card Creation
When required a Master SIM card can be created by:
Step 1: Insert a Transfer card into a unit which is already configured in the
desired way.Turn the unit on, the display should show‘Clone’.
Step 2: Enter 024# via the units keypad.This command copies the personality