User manual

User Manual Rev 1.0 31
8. Touch screen operation
In order to use the touch screen with a PC, touch screen drivers (for the operating system
being used on the PC) need to be installed.
This chapter provides an overview of the steps to install the touch screen drivers on a PC
running Microsoft Windows XP (the process is similar for other versions of Windows). It
then describes how to calibrate the touch screen, and provides an overview of using the
touch screen. (Drivers are available for other operating systems, including Linux and
QNX. Refer to Motium’s web site.)
Note
If the monitor has a USB touch screen interface, do NOT plug the USB
connector into the computer until the driver installation process tells you to.
Otherwise, the driver may not install correctly. Once the driver is installed, the
monitor’s USB connector can remain plugged into the computer.
If the touch screen is connected to the PC via the RS232 interface, the RS232
connector can be plugged into the computer at any time.
8.1. Driver CD
Drivers are available from Motium’s web site. To minimise environmental waste, Motium
does not ship a Driver CD with the product.
Note
The name of the driver file listed below is correct at the time of writing this
manual. The name may change slightly in future as a result of driver updates.
The updated drivers can be found on Motium’s web site.
8.2. Touch Screen driver
The driver file to use for this is:
Touch_Driver_5.0.0.5203.zip
This same file is also used for Windows 2000 and Vista. A different file is needed
for Windows 7.
Extract the contents of the ZIP file to a folder.
To install the driver:
 Double click on the setup.exe file in the
Touch All_In_One_2k_XP_Vista_5.0.0.5203 folder.
 Press Run.
 This brings up the TouchKit window. Press Next.
 Leave the Install PS/2 interface driver box un-ticked, and press Next.
 Leave None selected and press Next.