User guide

Veloce 50 Operating Manual
5
3 INSTALLATION
3.1 LINE POWER CONNECTION
1. Check to see that the line voltage is within the limits specified above;
CAUTION: Operating the instrument on an incorrect line voltage may cause damage to
the instrument, possibly voiding the warranty.
2. Before plugging in the power cord, make sure that the power switch is in the off (0) position;
3. Connect the female end of the supplied power cord to the AC receptacle on the rear panel. Connect
the other end of the power cord to a grounded AC outlet;
WARNING: The power cord supplied with the Veloce System contains a separate
ground wire for use with grounded outlets. When proper connections are made,
instrument chassis is connected to power line ground through the ground wire in the
power cord. Failure to use grounded outlet may result in personal injury or death due
to electrical shock.
4. Turn on the instrument by setting the power switch on the rear panel to the on (1) position. The Green
Status LED indicator will lit up on each Veloce module approximately 1 second after power up,
showing that it is working and that acquisition and processing has started.
Either the power cord or the AC mains switch are used as disconnecting device; make
sure that they remain accessible at all time after installation of the unit