Instruction Manual

60 Chapter 2 Using your J3500 Using the smart card reader (optional)
After you restart the computer, you should configure the authentication rules for strong
logon security.
To configure authentication rules
1. Start Motion OmniPass (page 55).
2. Tap Change Your OmniPass Settings.
3. Tap Set user authentication rules and policies.
4. Select the appropriate authentication rules.
5. Tap OK.
Using the smart card reader (optional)
Your tablet may include a smart card reader located on the right side of the tablet PC, under
the card slot cover, next to the pen bay.
Using smart card software, this device can read information from and write information to
the smart card when the card is inserted into the slot. The smart card is an ISO 7816 PC/SC
compliant, contact type smart card reader/writer.
Depending on the smart card software you are using:
• You may receive an acknowledgement for when the smart card is fully engaged in the
reader.
• You may receive a prompt or be required to shut down the software before removing the
smart card.
• Some smart cards may require you to insert the smart card for authentication, and then
remove the smart card when authentication is completed.
• Some smart cards may require keeping the card in the reader while the smart card
software is running.