User's Guide

Chapter 2 Using your CL920 Using 4G LTE mobile broadband with GNSS 41

3. Beside Power Switch on battery, select what you want to happen when the power

switch is pressed while the tablet is running on battery.

4. Beside Power Switch plugged in, select what you want to happen when the power

switch is pressed while the tablet is plugged into an outlet.

Using 4G LTE mobile broadband with GNSS

Your Tablet PC may be equipped with an optional embedded 4G LTE mobile broadband

with GNSS module. Mobile Broadband access requires an account with a Mobile Broadband

network carrier. To use the GNSS receiver, you don’t need a network connection or an

account with a Mobile Broadband network carrier.

Enabling 4G LTE Mobile Broadband with GNSS

Before you can establish a Mobile Broadband connection or use the Mobile Broadband

GNSS receiver, you must ensure that Mobile Broadband is enabled in Motion Tablet Center.

OTE: To reduce power consumption when running only on battery power and when 4G LTE

Mobile Broadband with GNSS isn’t being used, disable Mobile Broadband in Motion Tablet

Center.

To enable Mobile Broadband:

1. Open Motion Tablet Center and tap Power.

2. Tap the switch beside Mobile Broadband to turn it on.

Using Integrated u-blox 7-based augmented GPS

The GPS with SBAS receiver uses satellites to provide the current location, altitude, heading,

and horizontal velocity of the tablet through a virtual communications port. The module

supports the Wide Area Augmentation System (WAAS) for improved accuracy in the United

States; European Geostationary Navigation Overlay Service (EGNOS) for improved accuracy

in Europe; and Multi-functional Satellite Augmentation System (MSAS) for improved

accuracy in Japan. The proper Augmentation system will be detected based on your

location. No special selection is required. The augmentation feature uses signals from

geostationary satellites to improve on the reliability and accuracy of the signals from the

GPS satellites. There is no user interface for the GPS with SBAS receiver and the GPS with

SBAS receiver is always on whenever the tablet is powered on. The virtual communications

port that is assigned to the GPS with SBAS receiver by Windows can be viewed in the

Control Panel System Device Manager.

OTE: To use the GPS with SBAS receiver, you don’t need a network connection or an account with

a Mobile Broadband network carrier or service provider.