Instruction Manual

Safety warnings for sensor insole application
Safety Instructions
The sensor insole is not an orthotic. In case an orthotic is used by the wearer, the attentding
doctor must be consulted about wether it can be replaced by the sensor insole.
The sensor insoles must be worn only pairwise (both left and right) on order to avoid
asymmetric gait.
Only sensor insoles with appropriate size may be worn. Incorrect sizes (too small, too big, or
improper fit) are potentially dangerous, may be damaged during walking, and cause erroneous
measurement values. Check the proper fit of the sensor insole after insertion into the shoe.
The sensor insole may only be worn in closed footwear.
Immediately stop wearing sensor insoles in case of pain or skin irritation.
The weight of the wearer wearing the sensor insole may not exceed 120 kg.
Remove the coin cell battery from both insoles after finishing a measurement, or when the
coin cell battery is not used for some time. Store the sensor insole only without coin cell battery.
In case of an internal fault, surface temperature of 41 °C to 43 °C may occur, consituting a
possible temperature hazard.
The sensor insole may not be worn with open wounds or ulcers.
The sensor insole must be worn with socks in order to avoid direct skin contact.
See the detailed product information on www.moticon.de/insole3-specs and tutorial videos
about correct sensor insole handling on www.moticon.de/support
The battery compartment must face down towards the floor when insertig the sensor insole
into a shoe.
10
Moticon SCIENCE Insole Instruction Manual 03.00.00