User guide

MoTeC Installation 25
Sensor Wiring
M oTe C can supply wiring details for all sensors.
MoTeC Supplied Wiring Loom
M oTe C can supply either partial or complete wiring looms to suit each
application.
Custom Wiring Loom
If creating a custom wiring loom the following important points should be
observed.
Connector
The ADL uses a 79 pin Auto Sport connector, see Appendix M: Connector for
full details.
To ensure that the connector is sealed plug unused holes with filler plugs. A
heat shrink boot may also be used if desired.
Crimp Tool
The correct mil spec crimping tool must be used for the ADL crimp pins. See
Appendix M: Connector for details.
• Note that the Crimp Contacts are type 22D which is needed to set the
crimp tool correctly.
CAN Bus and CAN Cable Wiring
Refer to Appendix G: CAN Wiring - Multiple Device and or Appendix H: CAN
Wiring - Single Device for details.
External Buttons
A number of external buttons are required for various functions of the ADL.
Typically these buttons are used for:
• Display Mode