Installation guide

MOST Installation Guide
iPod & Bluetooth Installation Instruction Manual
www.mobridgeinc.com
ASIA-PACIFIC
Address 2/88 Northgate Drv Thomastown Melbourne VIC 3074
Phone [phone]
Inquiries [e-mail]
EUROPE
Address Marconiweg 15 3899 BR, Zeewolde The Netherlands
Phone [phone]
Inquiries [e-mail]
NORTH AMERICA
Address 3053 Fillmore St Unit 222 San Francisco California 94123
Phone [phone]
Inquiries [e-mail]
Introduction
2010 Fiberdyne Systems Pty Ltd
mObridge A2010/A2011 iPod solution emulates a CD Changer and uses
CD Changer controls to access off-board audio sources including iPod
and AUX devices. If your car is not already equipped with a CD Changer,
it may be necessary to have the car programmed by your dealer in
order to use the mObridge A2010/A2011 with it. CD Changer retention
is not supported.
mObridge ABT2010/ABT2011 iPod and Bluetooth solution is an A2010/
A2011 plus the additional functionality of Bluetooth hands-free
connection in vehicle, by emulating the Bluetooth controls already
featured. If you car is not already equipped with a Bluetooth system, it
may be necessary to have the car programmed by your dealer in order
to use the mObridge ABT2010/ABT2011 with it. CD Changer retention
is not supported.
mObridge M1000-M-BT1 Bluetooth solution emulates the Bluetooth
controls featured in the vehicle. If you car is not already equipped with
a Bluetooth system, it may be necessary to have the car programmed
by your dealer in order to use the mObridge M1000-M-BT1.
mObridge M1000-M-DA1 Digital Pre-Amp offers digital signal directly
into an aftermarket sound processor via TOSLINK, it maybe necessary to
have the car programmed for Factory amplifier by your dealer in order
to use the mObridge M1000-M-DA1.
For system setup please see: mObridge WIZARD Guide
2010 FIBERDYNE SYSTEMS PTY LTD
01
Programming
the car for mObridge products:
PLEASE NOTE PROGRAMMING VARIES BY REGION
AUDI
A2010 – no coding is required
ABT2010/M1000-M-BT1/DA1 – MMI software should be updated to 3360 to 4200 (YYYY)
BMW
A2010/ABT2010/M1000-M-BT1/DA1 – ALL BMW vehicles are required to be
“coded” - ie have CD Changer enabled in the vehicle. This requires some knowledge
and access to Autologic diagnostic tool.
LAND ROVER
A2011/ABT2011/M1000-M-BT1/DA1 – Generally no programming is required
but in some cases (e.g. no device was connected onto the optical ring) it is
needed to enable a Bluetooth with service computer.
MERCEDES BENZ
A2010/ABT2010/M1000-M-BT1/DA1 – Generally no programming is required
but in some cases (e.g. no device was connected onto the optical ring) it is
needed to enable a Bluetooth/CD Changer with StarDiagnose tool.
MINI
A2010/ABT2010/M1000-M-BT1/DA1 – ALL BMW vehicles are required to be
“coded” - ie have Bluetooth/CD Changer enabled in the vehicle. This requires
some knowledge and access to Autologic diagnostic tool.
PORSCHE
A2010/ABT2010/M1000-M-BT1/DA1 – Generally it is needed to enable a Bluetooth/
CD Changer with the PIWIS service computer but in rare cases the PCM accept
the mObridge without this enabling process.
2010 FIBERDYNE SYSTEMS PTY LTD
MOST Network
connection
MOST
BYPASS SWITCH
4 WHITE3 BLUE
2 RED1 BLACK
SEE CHART BELOW
Connection to iPod
iPod
Microphone for
ABT2010 only
MICROPHONE
Optical Loop for
ABT2010 only
OPTICAL LOOP
Connection to
AUX source
AUX
MEMORY CARD
Please Note When Servicing Your Vehicle You must set the mode selector switch to service mode
(bypass CD Changer) postion otherwise the service computer may detect an unknown device in the
fiber optic system which can lead to errors reported.
WIRE | COLOUR DESCRIPTION USE IN A2010/11 I ABT2010/11 I XMD-A2010
1 | Black GND Ground (Battery --)
(Battery - GND) Terminal 31 Klemme 31 / Kl.30
2 | Red Constant 12V Power (B+ constant)
Terminal 30 Klemme 30 / Kl.30
3 | Blue varies Not used
4 | White bypass or “Valet” MOST
“valet” input bypass switch
02
A2010/11
|
ABT2010/11
|
XMD-A2010
Package Content & Electrical Installation
USB | SD
TOSLINK
for M1000-M-DA1
Microphone
for M1000-M-BT1
MICROPHONE
MOST Network
connection
MOST
SEE CHART BELOW
BYPASS SWITCH
4 WHITE3 BLUE
2 RED1 BLACK
Please Note When Servicing Your Vehicle You must set the mode selector switch to service mode
(bypass CD Changer) postion otherwise the service computer may detect an unknown device in the
fiber optic system which can lead to errors reported.
M1000-M-BT1
|
M1000-M-DA1
Package Content & Electrical Installation
2010 FIBERDYNE SYSTEMS PTY LTD
03
WIRE | COLOUR DESCRIPTION USE IN M1000-M-DA1 USE IN M1000-M-BT1
1 | Black GND Ground (Battery --) Ground (Battery --)
(Battery - GND) Terminal 31 Terminal 31
Klemme 31 / Kl.30 Klemme 31 / Kl.30
2 | Red Constant 12V Power (B+ constant) Power (B+ constant)
Terminal 30 Terminal 31
Klemme 30 / Kl.30 Klemme 31 / Kl.30
3 | Blue varies Remote Amp Trigger Output Not used
4 | White bypass or “Valet” MOST bypass switch “Valet” MOST
“valet” input bypass switch
2010 FIBERDYNE SYSTEMS PTY LTD
Installation Notes AUDI
CD CHANGER
MAIN MMI
CONTROL UNIT
OTHER MOST
DEVICES*
Arrows point in the direction of the light.
LIGHT IN & OUT
TV Tuner, Navigation etc
*
OPTIONAL EQUIPMENT
LIGHT INLIGHT OUT LIGHT INLIGHT OUT
LIGHT INLIGHT OUT
LIGHT OUTLIGHT IN
LIGHT’S DIRECTION OF TRAVEL
Also what you see
Installation Notes BMW
Please see: Audi vehicle compatibility chart for application guide.
Please see: BMV vehicle compatibility chart for application guide.
04
OTHER MOST
DEVICES*
CD CHANGER**
HEAD UNIT
OR CCC UNIT
Arrows point in the direction of the light.
LIGHT IN & OUT
**
has to be “looped out” of the MOST
ring if iPod functionality is required.
TV Tuner, Navigation etc
*
OPTIONAL EQUIPMENT
LIGHT INLIGHT OUT LIGHT INLIGHT OUT
LIGHT INLIGHT OUT
LIGHT OUTLIGHT IN
LIGHT’S DIRECTION OF TRAVEL
Also what you see