Manual

* FWD. SEAL RING
INERTIA WT
OPERATING HANDLE
FOREND
* "O" RING
— MAGAZINE TUBE
INNER RING *
FOREND CAP
* Fwd sea! ring, inner ring, "o" ring and gas cylinder cover are not used on
the Model 9200A1.
Note: 9200A1 outer ring is pre-assembled with an inner ring.
Fig-5
* The rubber "O" Ring should remain on the magazine tube. Fit the barrel extension
into the receiver while sliding the gas cylinder over the magazine tube (Fig. 6).
* The barrel assembly includes a gas cylinder cover to protect the valve system
(Fig. 7). Models with synthetic forends include a sleeve spacer.
Grasp the barrel securely and push it into the receiver, forcing the bolt rearward until it
stops. The face of the bolt should be approximately 1/2 in. from the rear of the ejection
P°
rt
- BARREL
EXTENSION
RECEIVER TANG BARREL EXTENSION
MAGAZINE TUBE
GAS CYLINDER AND
* GAS CYLINDER COVER
* Fwd seal ring, inner ring, "o" ring and gas cylinder cover are not used on the Model 9200A1.
Fig. 6
While maintaining pressure on the barrel, pull the operating handle rearward until the bolt
locks in the open position. This will allow the barrel to seat fully into the receiver.
Re-install wood forend(or sleeve spacer and synthetic forend) and screw magazine cap
into the magazine tube. Tighten by hand.