Specifications

MosquitoBite Planes Robin 3
Glue Rib G1 on the outboard side of Rib G.
Dryfit the upper and the lower
1
/ 4" x
1
/ 8" sticks into the slots of
every Rib behind the Rear Spar. (See Plan Sheet 2)
Glue two Aileron Cable Anchors into the slots of Rib G1 as shown
in Figure 4.
Trim flush the sticks that protrude from the inboard upper and
lower Main Spar and Rear Spar, as shown in Figure 5.
Repeat the “Constructing the Leading Edge Spar” instructions to
create the opposite side of the wing.
Test the connection of each Wing-side to the Wing Cage,
as shown in Figures 6 and 7.
Glue the Wings to the Wing Cage in all places where contact is made.
Using thin CA, glue the Rear Spar and its upper and lower balsa
sticks in place.
Glue both Flap Cable Anchors into Rib D. They line up with the
hole on the Rear Spar. Repeat for the opposite side of the wing.
Apply a bead of glue to the joint of each Rib and Main Spar as
well as to the joint of each Rib and Rear Spar.
Dryfit a
3
/ 16" square stick to the leading edge of each Wing from
Rib A to F1(the half-rib). See plan sheet 2 for details.
Use masking tape to hold each stick in place while glue cures.
Slide Rib G1 in
Fig 4
Fig 5
Fig 7
Fig 6