Specifications

MosquitoBite Planes Robin 1
The Wing
Wing Construction
Glue and clamp together Main Centre Spar layers, to create the
laminated Main Centre Spar and Rear Centre Spar. Leave to dry.
The three pieces that make up the Main Centre Spar must be
glued together very precisely. Each of the 3 pieces have a slight
lengthwise curve. Ensure the insides of the curves face each other
(this cancels out any over-all curve) and glue together.
Repeat this method to laminate the two layers of the Rear Centre
Spar and the two layers of the Wing Bolt Beam.
Assembling the Wing Cage
The gluing of the Wing Cage must be done quite rapidly.
Therefore, we suggest you familiarize yourself with the Cage
assembly by dryfitting the following pieces as shown in Figure 1
• Main Centre Spar - 3 parts
• Rear Centre Spar - 2 parts
• Wing Servo Tray
• Rib A (x2)
• Wing Bolt Beam - 2 parts
If any parts are too snug, perform minimal sanding.
Disassemble and continue with these gluing instructions:
Along the front and back edges of the Wing Servo Tray, run a line
of glue. Immediately connect the Main Centre Spar to the Tray’s
front, and the Rear Centre Spar to the Tray’s back.
Glue the rear edge of the Wing Bolt Beam and install in place
along the front of the Main Centre Spar.
Run a line of glue along both side edges of the Wing Servo Tray,
and along the sides edges of the Wing Bolt Beam.
Slide Rib A along the Spars. The letter “A” on each Rib, should both
be facing the Wing Servo Tray. Connect both Rib A parts into the
tabs of the Wing Servo Tray and the Wing Bolt Beam.
Before the Wing Cage cures, place a heavy weight in the centre of
the Wing Servo Tray to ensure all parts dry flat and square.
Fig 1