Specifications

MosquitoBite Planes Robin 35
Main Landing Gear
To get access to the Undercarriage Mount, the Fairing must first
be carefully cut out.
Use a razor blade to cut beyond the laser-cut lines as shown
above.
The blade should cut in at 45˚ angle along the lengthwise cut.
Carefully remove the Fairing, revealing the installed Blind Nuts.
(Save this Fairing section for a later step.) The Blind Nuts will
protrude to aid alignment of the Main Landing Gear.
Place the Main Landing Gear over the Blind Nuts and mark the
corner balsa where the edge of the Gear sits. Cut a channel into
the corner balsa (see arrows) to allow the Gear full contact with
the Undercarriage Mount.
The Main Landing Gear needs to be sanded to match the profile
shown on Plan Sheet 1. A serious tool will be needed to perform
this. Shown here, the sanded Main Landing Gear is in place.
Locate the 5 parts that make up the Main Gear Fairing. Glue
together as shown above. Refer to Plan Sheet 1.