Specifications

MosquitoBite Planes Robin 31
Glue both Lower Cowl Arms (LC4) into LC1. The Arms are meant
to be loose to allow them to lean in, supporting F1C.
Glue F1C onto the Lower Cowl Arms and LC2.
Use caution when letting these assemblies cure. Butting them up
against each other will ensure a true fit when they cure.
While things dry, there are a few things to take care of.
Using
1
⁄2" triangle stock, cut some supports for the corner behind
the Firewall. Sanding will be required to match the 95˚ corner
before gluing the supports in place.
Supplied are two studded blind nuts. Use epoxy and drop them
into the holes of the Undercarriage Mount. Be careful not to
contaminate the threads with epoxy.
Install your engine mount. If you are using an OS .46AX, we
recommend using a Dave Brown 46-50 Engine Mount. The
Firewall is already “pre-drilled” for it.
Locate the supplied brass tubing and cut two pieces, each 1"
long. Use epoxy to glue these into the Fuel Line Passages on the
Firewall. The tubing should protrude equally from both sides.