Specifications

28 MosquitoBite Planes Robin
Position the remaining port side Rudder sheet. Pinch the trailing
edge together while applying CA glue. Be careful not to
introduce distortion to the trailing edge.
Sand the trailing edge to a point. If there was some distortion in
the trailing edge, you now have the opportunity to sand it out.
Use a balsa stripper to cut a strip of
3
⁄32"x
3
⁄32" balsa. Allow an inch
extra at the lower end for the next step. Glue it to the starboard
leading edge of the Rudder.
Use scrap balsa to make a small block for the bottom of the
Rudder. It should be thick enough to make the height of the
Rudder equal to the trailing edge of the Vertical Stab. (Test
frequently.)
Sand the lower edge to match the profile shown on Plan Sheet 1
and the Fuselage contours.