Specifications

26 MosquitoBite Planes Robin
Completing the Tail
Pull the Elevator Cable half-way out of its Sleeve and hook up the
Elevator Cable to the Elevator Horn. Be sure to use a keeper.
Slide the Horizontal Stab into place temporarily removing F12 in
the process.
Take great care to make sure the Horizontal Stab is straight and
centred. Use CA to lock it in place.
Install & glue F12 with CA, and the Fuselage Sidewalls Parts D.
Revisit the Horizontal Stab with wood glue around all areas where
contact is made with the Fuselage.
Assemble and glue the 7 pieces of the Vertical Stab (VS1 - VS7) as
shown on Plan Sheet 1. Be careful to set the Ribs in the right
orientation.
Cut a section of
1
⁄4" triangular balsa to go along the back of the
Vertical Stab. The length of the stock must reach past the bottom
of F12. See Figure 54 on the next page. Note the orientation of
the stock in Figure 52.
Before the Vertical Stab can be installed, part of the walls around
F12 needs to be removed. Trim the starboard Sidewall and both
lower corner sheeting, as shown in Figure 53.
Fig 52 Fig 53