Specifications

24 MosquitoBite Planes Robin
Trim back the top sheeting as shown and carefully sand to the
angle of the formers (black arrows).
Locate and glue on one set of Balsa Hatch Doublers, being careful
to match the profile of the Hatch (white arrows).
Temporarily position the Wing on the Fuselage. Clamp the Wing
to the Fuselage when the Wing position is straight.
Use a
1
⁄4-20 Tap to cut threads into all four holes of the Fuselage
Bolt Plates. Add
1
⁄4-20 Nylon Bolts as you complete each hole.
Insert the Hatch into the Fuselage with the Wing in place.
Carve an opening in the top sheeting to allow the Hatch Nylon
Bolt to become recessed.
Using the same
1
⁄4-20 Tap, cut threads into the hole of the Hatch
Bolt Plate While the Hatch is seated.
Once the Hatch is bolted down, use thin CA to glue the second
set of Balsa Hatch Doublers into place. This is done by pressing
down on the Wing with the Doubler - removing all possible gaps.
Remove the Hatch to complete the gluing process.