Specifications

MosquitoBite Planes Robin

Dryfit one H.S. Base Sheet onto the upper tabs of the H.S. Ribs.

Use thin CA to glue this Base Sheet in place. Commence the

gluing along the H.S. Spar.

When the Base Sheet tab opening, sides and Spar edges are

glued, pinch together the H.S. Base Sheet and Top Sheet. Use thin

CA to glue the forward tips of these two pieces together.

Finally, to close the centre of the Horizontal Stab, locate the

reserved 1

⁄8" x 3" piece of balsa sheeting. Slide into the opening

between the two Base Sheets by cutting open two small slits

along the H.S. leading edge to accommodate its width.

Once in place, use something thin and strong to push the balsa

scrap up against the inside of the Base Sheets. Use thin CA glue

to secure it in place.

To create the tips of the Horizontal Stab, first sand each end of

the H.S. flush (using block sander).

Next, locate the 10 balsa H.S. Tips. Use CA to glue four H.S. Tips to

each other, and finally to glue this laminated H.S. Tip to each end

of the Horizontal Stab.

Sand the leading edge of your Horizontal Stab to match the

profile shown on Plans Sheet 1.

Creating the Elevator

Locate:

• 2 Elevator Base Sheets. (deeper than the Top Sheets.)

• 2 Elevator Top Sheets

• 10 Elevator Ribs

• 2 Elevator Spars

• 4 Elevator Doublers

On each Elevator Top Sheet, you will use thin CA to glue on the

Elevator Ribs – 5 per side. Ribs should sit within the depth of the

base. If a Rib extends beyond one side, it is facing the wrong way.

Keep each Rib as vertical as possible as you apply CA to its base.

Top Sheets Shown

H.S. shown upside down