Specifications

16 MosquitoBite Planes Robin
Sand the protruding Rudder Control Cable Sleeve flush with the
Fuselage Sidewall. The Cable will need to be withdrawn from this
section of Rudder Sleeve.
Except for F12, CA glue the Fuselage Top Sheet to all Formers.
Remove only the tape that holds the Fuselage Top Sheet against
the Sidewalls. Now the tricky step: without getting CA on F12, use
thin CA to glue the Fuselage Top Sheet to the Fuselage Sidewalls
where they connect.
Remove the remaining tape and set aside Fuselage Sidewalls
Parts D.
Locate little F11A. Dryfit F11A into the Fuselage Top Sheet slot,
above F11B. Glue with thin CA.
The Tail Gear and Steering Arm
Locate the Steering Arm.
Cut back the arm’s length, leaving only one hole. See Figure 40.
Install the EZ Connector and its screw.
We recommend replacing the slotted screw from the Steering
Arm with the black socket head bolt which we have supplied.
Slide the Rudder Cable into the EZ Connector on the Rudder
Servo Arm. Partially pull the back end of the Rudder Cable out of
the Fuselage through the large Horizontal Stab opening.
Slide the Cable through the EZ Connector on the Steering Arm.
Match the orientation of your Steering Arm shown in Figure 41.
Carefully pull the Cable and Steering Arm back into the Fuselage.
Manoeuvre the Steering Arm into the Tail Wheel Block.
Fig 40
F11A
Fig 41