Specifications

Steering Block

Locate F8 and F9. Apply glue to their side edges. Install each

between the Fuselage Sidewalls, making sure that the “Star” is on

the starboard side. Clamp until glue cures.

Refer to diagram on Plan Sheet 1 for the Tail Steering Block and

assemble it with wood glue. Be sure to glue the assembly on the

back side of F10. When glue is cured, Install F10 into position. See

Figure 34.

Glue the sides of F11B. The side hole goes on the starboard side.

Install and clamp until cured. Temporarily dryfit the Fuselage

Floor; this will ensure F11B cures at the correct angle. Remove

when F11B has cured.

Elevator Cable Sleeve

Lay the supplied 36" Cable Sleeve on the plans and cut the

Elevator Sleeve to length. Install this in the hole of F5A on the

port side as shown in Figure 35.

This Sleeve must follow the Elevator Cable Path shown on Plan

Sheet 1. Glue in place with thin CA. See Figure 36.

Rudder Cable Sleeve

Lay the supplied 36" Cable Sleeve on the plans and cut the

forward (longest) Rudder Sleeve to length. Install this in the

starboard hole of F5A, and guide it along the Rudder Cable Path

shown on Plan Sheet 1. Glue this forward section of Rudder

Sleeve in place with thin CA. See Figure 36.

Install three Servos into the Fuselage Servo Tray, in the orientation

shown in Figure 35 and Plan Sheet 1 .

Trim to length the small, remaining section of Cable Sleeve for

the Rudder Cable/Tail Wheel, and dryfit it, as shown on Plan

Sheet 1. It exits through the Fuselage Sidewall; see Figures 36 and

37 to help guide you in creating this opening.

Install the full 36" of Rudder Cable Wire.

Use thin CA to glue the remaining Rudder Cable Sleeve in place.

MosquitoBite Planes Robin

Fig 34

Fig 35

Elevator Cable

Rudder Cable

F11B

Fig 36

Fig 37

F11B