Specifications

Remove the Fuselage Sidewalls & Floor from the main structure.

Locate a

8" square stick. Install it vertically down between the

edges of F5A and F5B. Trim the lower part of the stick to match

the Formers’ diagonally cut bottoms.

At the top, you must cut out part of the stick to match the

Former shape as well. Repeat for the opposite side.

Repeat this process again between F6A and F6B. See Figure 26

which shows only the right side done between the two sets of

Formers.

Using tape, temporarily install F3A. Glue both Fuselage Sidewalls

onto the Formers assembly. Turn on its side and apply weight.

Allow time for curing.

Apply glue to the rear edge of the Fuel Tank Floor and to the two

side edges of F3B.

Plug the end of the Fuel Tank Floor into F4 while fitting F3B into

the Fuselage Sidewalls as shown in Figure 27.

Locate F7 and the four pieces for the Hatch Bolt Assembly (HB1, HB2

and 2x HB3)

Glue face to face, HB1 and HB2 ensuring the bolt holes are

aligned. This is your Bolt Plate.

Glue the Bolt Plate into both HB3 parts.

It is VERY IMPORTANT that you attach the Hatch Bolt Assembly to

the correct side of F7. It must attach to the forward side of F7. See

Figure 28. or see Plan Sheet 1. Glue only when you are certain.

MosquitoBite Planes Robin

Fig 26

Fig 27

Fig 28