Specifications

MosquitoBite Planes Robin 11
Locate Main Servo Tray.
Glue it into the slots midway up F5A, as shown in Figure 22.
Apply glue to the exposed edges of the Undercarriage Mount,
the Side Support Walls and the Main Servo Tray.
Install F4 on these glued edges.
Before glue cures, temporarily dryfit the whole assembly into
the slots of both Fuselage Sidewalls and Fuselage Floor - ensuring
all parts cure in perfect alignment. See Figure 23.
Locate the Airvent Sidewalls. (two “A” and two “B” parts)
Glue each A to a B, keeping the centre holes aligned.
Glue each laminated Airvent Sidewall into the slots on F3B, as
shown in Figure 24. (Parts A are closest to the F3B centre hole.)
On both Airvent Sidewalls, apply glue to the long edges that
sport tabs, and install the Fuel Tank Floor as shown in Figure 25.
Fig 22
Fig 23
Fig 24 Fig 25
Fuel Tank Floor