Specifications

10 MosquitoBite Planes Robin
Locate the Fuselage Bolt Plates, three A and two B parts.
Sandwich one B part between both A parts and test fit this
laminated beam into the top slots of F5B before applying glue.
Use lots of glue to laminate all three beams altogether and glue
them into the slots along the top of F5B as shown in Figure 19.
Glue the long edge of the laminated Beam and the edges of the
Battery Box and install F5A on these glued edges. Use large pliers
to coax the top of F5A to connect with the Beam properly.
Laminate the remaining two Fuselage Bolt Plates, one A and one
B. With lots of glue, install this laminated Bolt Beam to the back of
F6A.
Glue the long edge of this last laminated beam and the edges of
the Battery Box and then install F6B. Use pliers to coax the top of
F6B to connect with the Beam.
Locate the Undercarriage Mounts, A and B, and the two Side
Support Walls.
Glue Mounts A and B face to face, making sure the holes are in
perfect alignment.
Before the glue cures, glue in place the Side Support Walls, as
shown in Figure 20.
Apply glue to the edge of the Undercarriage Mount (the edge
opposite the holes) and to the edges of the Side Support Walls.
Install this into the lower slots on F5A. See Figure 21.
A
B
Fig 19
Fig 20
Fig 21