Specifications

MosquitoBite Planes Robin

Fuselage

Locate the following:

• Battery Box Walls

• Battery Box Floor

• Firewalls: F2A and F2B

• Formers: F3B to F13

• Fuselage Bolt Plates, three A & two B parts.

• Undercarriage Mounts, A and B

• Side Support Walls

• Main Servo Tray

• Airvent Sidewalls, two A & two B parts.

• Fuel Tank Floor

• Fuselage Sidewalls

• Fuselage Floor

• Hatch Bolt Assembly

• Wing Saddle Doublers

• Two Hatch Hooks

• Tail Steering Block Parts

Constructing the Fuselage

Locate both parts of the Firewall - Formers F2A and F2B.

Place F2A and F2B back to back . The writing on both formers

should face outward.

Glue and clamp these together, ensuring all holes are aligned.

F2B is intentionally wider and taller than F2A. Set aside to cure.

Main Cage

Locate the three parts of the Battery Box. Refer to Figure 18: Glue

the Battery Box sides to the floor.

Locate Formers F5B and F6A.

Apply glue to the inside edges of both F5B and F6A.

Insert the Battery Box through them. (F6A goes nearest the upper

hooks on the Battery Box.) Lift the Battery Box up into position

and push out the Box walls to fit onto the tabs of the Formers,

F5B and F6A.

Hardware

4 Cable with Sleeve, Steering Arm, and 2

Clevises.

Pre-Assembly

The Fuselage Sidewalls and Floor need to be

pre-assembled as shown below. Ensur

e that

both Sidewalls are perf

ectly identical to each

other before using.

Fig 18