Specifications

MosquitoBite Planes Robin 5
Position each Aileron at the edge of a table and use a sanding
block to sand the edge of the Aileron Base Sheet to a fine point.
Locate the two Aileron Top Sheets.
Dryfit each Top Sheet along the upper tabs of the Aileron
Ribs/Horn.
Wick thin CA glue into the tabs of each Aileron Rib/Horn. (Note:
To avoid a twisted Aileron, hold the assembly down on a flat
surface as CA glue is applied.)
Once the Top Sheet has cured, sand the trailing edge to almost a
fine point. Cover Aileron with Ultracote and install the Mass
Balance along the full width of the Aileron. See Plan Sheet 2.
Creating the Flaps
Locate two Flap Base Sheets, eight Flap Ribs, two Flap Horns, four
Flap Horn Supports and four Flap Pivot Ribs.
Build both Flaps at the same time to prevent making two
left Flaps.
On the Base Sheets, dryfit the Flap Ribs in their slots as seen on
Plans Sheet 2. Use thin CA to glue in place.
Into the centre set of slots, dryfit the Flap Horn with Flap Horn
Supports on either side. Use thin CA to glue in place.