Specifications

4 MosquitoBite Planes Robin
Locate all eight Flap Support Arms.
Glue two Flap Support Arms to either side of Rib C and to either
side of Rib E as shown in Figure 8.
Before the glue cures, use a
3
/ 32" wire to align the hinge holes as
shown in Figure 9. Repeat for the opposite side of the wing.
Fig 8
Fig 9
Fig 10
Aileron Horn
Aileron Rib
Creating the Slot Lip (TE)
Locate the Trailing Edge Stock (
3
/ 16" x
3
/ 4"). Cut two pieces,
each 22" long.
Apply glue to the trailing edge of Rib A to Rib G on both sides of
the Wing, and install both pieces of Trailing Edge Stock.
Clamp until cured.
Creating the Ailerons
Locate two Aileron Base Sheets, eight Aileron Ribs, two Aileron
Horns, two Aileron Spars and two Aileron Top Sheets.
Build both Ailerons at the same time (facing each other) to
prevent making two left Ailerons.
On the Base Sheets, position the Aileron Ribs and Aileron Horns in
their slots. See Figure 10.
Dryfit the Aileron Spar into the End Slots of all Aileron Ribs and
Aileron Horns.
Making sure not to glue the Spar, apply thin CA to the base of all
the Aileron Ribs and Aileron Horns. (We don’t want to glue the
spar in yet.)
Remove the Spar and apply wood glue to the Aileron Ribs and to
the short edges of the Aileron Horns. Replace the Aileron Spar.
(Note: Ensure that no wood glue contacts the Aileron Base Sheet
to avoid warping.)