Operating instructions
13
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
Should the sensor system recognise such a situation, an acoustic signal will sound and the LED
display will blink for 2 minutes after the appliance has been switched off. The acoustic signal and
the blinking of the LED display can be cancelled by briefly switching the appliance on and off.
Before using the appliance again, it is
urgently recommended to clean the appliance and oil the
blade set. For this purpose, please proceed as follows (failure to observe these instructions may
result in damage to and early failure of the appliance and will void all guarantee claims):
· Switch off the appliance using the on/off switch (Fig. 2b).
· Remove the attachment comb and the blade set and use the cleaning brush to clean the open-
ing of the housing and the blade set. (Fig. 7).
· Oil the blade set (Fig. 8).
Changing the blade set
· Switch off the appliance using the on/off switch (Fig. 2b).
· The blade set can be removed by sliding it away from the housing in the direction of the arrow
(Fig. 6a).
· Replace the blade set by hooking it into the housing and pressing it down until it clicks into posi-
tion in the housing (Fig. 6b).
Disposal in EU countries
Do not dispose of the appliance with domestic refuse. As part of the EU Directive govern-
ing the disposal of electrical and electronic equipment, the appliance is accepted free of
charge by local waste collection points or recycling centres. Correct disposal will ensure
environmental protection and prevent any potentially harmful impacts on people and the
environment.
Disposal in non-EU countries
· Please dispose of the appliance at the end of its service life in an environmentally friendly
manner.
· Disconnect the plug-in transformer from the mains power supply and switch on the appliance to
discharge the battery completely.
· Remove the blade set (Fig. 6a) and use a screwdriver to remove the screws in the opening of
the housing (Fig. 9). Pull the housing parts apart and remove the entire drive with the PCB
(Fig. 10).
· Pull battery off circuit board. If necessary, use a screwdriver to pry them off (Fig. 11).
· Take the batteries to an appropriate collection point.
· Once the batteries have been removed, the appliance may no longer be connected to the
mains!