Product Manual

GE 6000/6500 SX/GS
GE 6000/6500 DES/GS-L
GE 7000 SX/GA© MOSA REV.1-09/06
M
21ENGINE STARTING - STOPPING THE ENGINE
21/10/04 35640GB
Do not alter the primary conditions of regulation
and do not touch the sealed parts.
NOTE
Check daily
STARTING THE ENGINE
lnsert the electric protection device (D) lever
towards above, see page M37 –
Introduce the key (Q1), turn it
clockwise completely, leaving it as
soon as the engine starts.
Let the engine run for some minutes before drawing
the load.
OFF
ON
START
RUNNING-IN
During the first 50 hours of operation, do not use
more than 60% of the maximum output power of
the unit and check the oil level frequently, in any
case please stick to the rules given in the engine
use manual.
CAUTION
If the engine fails to start, do not insist for at least
15 seconds.
Space the further operations waiting for at least
4 minutes.
CAUTION
STOPPING THE ENGINE
☞
Before stopping the engine it is compulsory to
effect the following operations:
- stop to draw three/single-phase current from the
auxiliary sockets.
OFF
ON
START
Make sure that the unit is not supplying any power.
Disconnect the electrical protection device (D) lever
downward.
Stop the engine turning the key (Q1) it
counter clockwise, OFF position, then
take it out.
☞
NB.: for safety reason the key must be kept
by qualified personel.