Product Manual

17/04/2020 CB2M1011_EN
ENGLISH
ENGLISH
REV.0-04/20
M
26.1
STOPPING
STOPPING
To stop the engine in an emergency, turn the engine switch to
the OFF position.
Under normal conditions, use the following procedure:
1) stop the power source, turning off the connected equipment,
if they do not have a power switch, open the main switch of
the machine (lever facing down)
2) allow the engine to run without any load for a few minutes
3) turn the starter key to the OFF position
4) Shut the gasoline cock.
SHUT-DOWN FROM REMOTE (only EAS version)
The unit can also be shut down by means of the TCM remote
control or EAS panel.
WARNING
The start-up selector (I6) LOCAL START / REMOTE START
enables the start-up and stop controls for the selected po-
sition.
From the REMOTE START position, the start-up key on the
front panel is completely disabled; to stop the generator, use
the controls on the TCM or EAS panel.
1. Check that the EAS (B3) connector is connected to the cable
from the TCM or EAS panel
2. Verify or position the LOCAL START / REMOTE START (I6)
selector on REMOTE START
3. SHUT-DOWN with EAS
The EAS panel automatically sees to controlling the motor
shutdown cycle, including the cooling cycle
4. SHUT-DOWN with TCM
Follow the same shutdown procedure described for
shutdown from the front panel using the TCM key (Q1).
!
CAUTION
RUNNING-IN
During the rst 50 hours of operation, do not use more than
60% of the maximum output power of the unit and check the
oil level frequently, in any case please stick to the rules given
in the engine use manual.
!