8 kva Honda Three Phase Petrol Auto Start Generator GE SX-8000 HBT

ManualsBrandsMosa ManualsDomestic Generators8 kva Honda Three Phase Petrol Auto Start Generator GE SX-8000 HBT

17/04/2020 CB2M1011_EN

ENGLISH

REV.0-04/20

STARTING

NOTE

Do not alter the primary conditions of regulation and do not

touch the sealed parts.

check daily

STARTING

1) Make sure the load plugs are

disconnected or that the main

switch of machine is open (lever

facing down), so as to ensure the

engine’s start-up without any loads

inserted.

4) then return it slowly

2) Open the gasoline cock

5) pull the rope hard and fast. Pull it all the way

out. Use two hands if necessary.

NOTE

All iGX engines are equipped with an automatic choke device

(AUTO CHOKE) which facilitates the start-up phase.

In this case the manual operation is not required.

ELECTRIC START

Start-up from front panel

1) Position the LOCAL START / REMOTE START (I6) selector

on LOCAL START (only EAS version)

2) Turn the starter key to position “ON”.

3) Turn the start-up key (Q1) to the START position, once the

engine is started up leave the key, it will reposition itself in

“ON”

4) Once the engine is started, let it turn for a few minutes before

drawing the load.

 In case of unsuccessful start-up, do not insist for longer

than 5 seconds. Wait 10 seconds before attempting

another start-up.

Remote start (only EAS version)

The unit can also be started by means of the remote TCM con-

trol device, or through the EAS automatic intervention panel.

1) Position the LOCAL START / REMOTE START (I6) selector

on REMOTE START;

2) check that the emergency stop button is unblocked (where

it is assembled);

3) Connect to the EAS (B3) connector the TCM or the EAS

panel;

4) Start-up with EAS

The EAS panel automatically sees to controlling the engine’s

start-up cycle.

5) Start-up with TCM

Perform the same procedure for start-up from the front panel

using the TCM start-up key (Q1).

3) hold the starting handle properly and pull slowly

until you feel resistance

 ATTENTION: Allow the start-up knob to re-enter slowly,

avoiding having it knock against the motor and thereby

damaging the start-up system.

MANUAL RECOIL FOR ELECTRIC STARTING VERSIONS

In case of lack of battery or low battery the engine can be

started manually.

After steps 1) and 2) of the STARTING paragraph, proceed

as follows:

1) position the LOCAL START / REMOTE START (I6) selector

on LOCAL START (only EAS version)

2) turn the start-up key (Q1) to the ON position.