User Manual

GE 12000 KSX/GS / AVR
GE 14000 KSX/GS / AVR
M
21
REV.0-04/14
Start-up
08/04/1435931-GB
checkbeforeeachstart-up
START-UP FROM FRONT PANEL
1. PositiontheLOCALSTART/REMOTESTART
(I6)selectoronLOCALSTART(only EAS ver-
sion);
2. check to ensure the emergency stop button is
unblocked(whereitisassembled);
3. makesuretheloadplugsaredisconnectedorthe
thermal-magneticswitch(Z2)isnot
inserted(intervention/insertionlever
facingdown),soastoensurethe
motor’sstart-upwithoutanyloads
inserted;
4. Makesurethattheacceleratorleverortheswitch
(16)isatitsminimumsetting;
5. lnsert the electric protection device (D-Z2-N2)
levertowardsaboveand,wheremounted,check
theisolationmonitor(A3)seepageM37-
6. Introducethekey(Q1),turnitclockwisecomple-
tely,leavingitassoonastheengine
startsand/orthepushbutton(32)(mo-
delswithoutkey)leavingitassoonas
theenginestarts.
+ NB.: for safety reason the key must be kept
by qualied personel.
7. Oncetheenginehasstartedleaveitrunningat
areducedspeedforsomeminutes.
8. Acceleratetheengineatmax.,setleveronma-
ximumpositionandthentakeupload.
+In case of unsuccessful start-up, do not in-
sist for longer than 5 seconds. Wait 10 - 15
seconds before attempting another start-up .
REMOTE START
(OnlyEASversion)
Theunitcanalsobestartedbymeansoftheremote
TCMcontroldevice,orthroughtheEASautomatic
interventionpanel.
1. PositiontheLOCALSTART/REMOTESTART
(I6)selectoronREMOTESTART;
2. checkthattheemergencystopbuttonisunblo-
cked(whereitisassembled);
3. ConnecttotheEAS(B3)connectortheTCMor
theEASpanel.
4. Start-up with EAS
TheEASpanelautomaticallyseestocontrolling
themotor’sstart-upcycle.
+ ThepreheatingtimeontheEASpanelisnormally
setat10seconds;forlowtemperatures,itmay
benecessarytoincreaseitto15or20seconds
toensurestart-up.
Contact an authorized Service Centre or our
TechnicalServiceDepartmentdirectlytomodify
thissetting.
5. Start-up with TCM
Performthesameprocedureforstart-upfrom
thefrontpanelusingtheTCMstart-upkey(Q1).
OFF
ON
START
Time
5min.
2min.
1min.
20sec.
Temperature
≤
-20°C
to-20°Cfrom-10°C
to-10°Cfrom-5°C
≥5°C
RUNNING-IN
During the rst 50 hours of operation, do not use more
than 60% of the maximum output power of the unit and
check the oil level frequently, in any case please stick
to the rules given in the engine use manual.
CAUTION
!