User Manual

ACCESSORY USE REMOTE CONTROL
TCM 5 - 5D - 6
M
38.5
© MOSA REV.0-09/08
When the TCM 5 5D-6 is used, it is not possible to connect the E.A.S automatic intervention unit.
MAKE SURE
USE OF THE REMOTE CONTROL TCM 5
The coupling of the TCM 5 with the generating set,
permits to work far from the set itself.
The remote control is connected to the front plate,
with a multiple connector.
The TCM 5 assures the following fonctions:
- starting (starting key Q1)
- stop (starting key Q1)
- choke control (L6)
1) the position of the selector LOCAL START/RE-
MOTE START (l6) on the generating sets GE
4500-7000-7500 HSX and GE 4500 SX-EAS
must be on the position "REMOTE START".
2) The position of the key (Q1) on the generating
set GE 4500 SX-EAS must be on the position
"ON"
USE OF THE REMOTE CONTROL TCM 5D
The coupling of the TCM 5D with the generating
set, ready for remot starting, permits to work far
from the set itself.
The remote control is connected to the front plate,
and/or rear plate, with a multiple connector.
The TCM 5D assures the following fonctions:
- starting (starting key Q1)
- acceleration (selector 16)
- stop (starting key Q1)
- indication of oil low pressure (warning light O1)
To stop the set, move the accelerator lever (16) to
the minimum position, them turn the key to "OFF"
position.
USE OF THE REMOTE CONTROL TCM 6
The coupling of the TCM 5D with the generating
set, ready for remot starting, permits to work far
from the set itself.
The remote control is connected to the front plate,
and/or rear plate, with a multiple connector.
The TCM 5D assures the following fonctions:
- starting (starting key Q1)
- stop (starting key Q1)
- indication of oil low pressure (warning light O1)
To stop the set turn the key to the position."OFF".
O1)
Per l’arresto del motore portare la chiave sulla posi-
zione "OFF".
PUSH AND
SCREW TIGHT
MAX
MIN
OFF
START
ON
Q1
OFF
O116
TCM 5D
TCM 5D
OFF
START
ON
Q1
OFF
O1
TCM 6TCM 6
PUSH AND
SCREW TIGHT
PUSH AND
SCREW TIGHT
29/11/99 M38GB