5 kVA Honda DC Arc Welder Generator Manual

29/11/19 C1UN7020_EN
ENGLISH
ENGLISH
REV.0-10/20
M
34
USE AS WELDER
This symbol (Norm EN 60974-1 security standards for
arc welders ) signies that the welder can be used in
areas with increased risk of electrical shock.
CONNECT WELDING CABLES
Assure the right ground connection (12) (when and if needed).
For this purpose see chapter “GROUND CONNECTION”.
WARNING
It is prohibited for any unauthorized persons to
access areas adjacent to the engine driven welder
or the welding process.
!
WARNING
The sockets, after the machine is started, also with no cables,
are anyway under voltage.
!
WARNING
To reduce the risk of electromagnetic interferences, use the
minimum length of welding cables and keep them near and
down (ex. on the oor).
The welding operations must take place far from any sensitive
electronic device. Make sure that the unit is earthed (see
M20 and/or M25). In case the interference should last, adapt
further disposition, such as: move the unit, use screened
cables, line filters, screen the entire work area.
In case the above mentioned operations are non sufficient,
please contact our Technical Assistance Service.
!
CAUTION
With a welding cable length up to 10 m is suggested a section
of 35 mm²; wìth longer cables a bigger section is required.
!
Fully insert the welding cable plugs into the corresponding
sockets turnning them clockwise to lock them in position. Make
sure that the ground clamp ,whose cable must be connected to
the + or - terminal, depending on the type of electrode, makes
a good connection and is near to the welding position. Pay
attention to the two polarities of the welding circuit, which must
not come in electric contact between themselves.
Carefully tighten the output cables to the bushings; if loose, they
can cause problems of overheating and damage the bushings,
cables, etc.
ONLY GOUGING
PUSH AND
TWIST
STARTING OF THE SET
During every start, selector must
be on position “GENERATOR”
to guarantee the alternator self-
energising.
Welding
Current
40-100-160
50-110-170
60-120-180
40A/90A
80-140-200
90-150-220
Range
Selection
Generator
160A/220A
70-130-190
100A/150A
WELDING CURRENT SETTING
In this function the selector must indicate the current range
indicated on the packing of electrodes that will be welded.
At last, using main welding current selector it is possible to set
the most suitable current to weld the used electrode.
Important: every time the machine is used as welder it is
necessary to disconnect the load from the sockets of the
alternator to
avoid any damage that can be caused by voltage uctuations
while the machine is welding.
WORKING AS GENERATOR
In this function selector must be on position “GENERATOR”
to allow to use of the sockets mounted on the rear panel.
Welding
Current
40-100-160
50-110-170
60-120-180
40A/90A
80-140-200
90-150-220
Range
Selection
Generator
160A/220A
70-130-190
100A/150A