7 kVA Honda 200A Three Phase DC Arc Welder Generator Product Card

MADE IN ITALY
language
WELDING GENERATOR
GM 7-200 HBT
FEATURES
• Arc welding source in D.C. welding
• A.C. generator, single-phase
• Protective frame with central lifting eye
• Engine shut down for low oil level (oil alert)
• Thermal protection for welding circuit
• Thermal protection for generator sockets
• Dierential protection (on request)
• Compliant with EC / EU Directives
air
cooled
diesel manual
recoil
WELDING PROCESS
Shielded Metal Arc
welding SMAW
(STICK)
DEFINITIONS
SMAW: Coated electrode welding is an arc welding with protected metal.
GMAW: welding is an arc process with metal under gas protection.
FCAW (FLUX CORED): The process with cored wires is very similar to MIG / MAG welding.
Continuous wire is not full but consists in a metal strip that wraps a powders core (flow).
GTAW: is a welding process that uses a tungsten electrode that cannot melt.
The images are for reference
4-TEMPI, OHV
Model HONDA - GX 390
* Stand-by net power 8.2 kWm (11.1 hp)
* PRP net power 6.4 kWm (8.7 hp )
* COP net power /
Cylinder / Dislacement 1 / 389 cm³ (0.39 lt.)
Bore / Stroke 88 / 64 (mm)
Compression ratio 8.2 : 1
BMEP (Brake Mean Eective
Pressure : LTP - PRP)
/
Speed governor type Mechanical
FUEL CONSUMPTION
110 % (Stand-by power) 3.5 lt./h
100 % of PRP 3.2 lt./h
75 % of PRP 2.4 lt./h
50 % of PRP 1.6 lt./h
25% of PRP
COOLING SYSTEM /
Total system cap. - only engine /
Fan air flow
EnginE 3000 rpm
LUBRIFICATION SYSTEM /
Total oil system capacity 1.1 lt.
Oil capacity in sump /
Oil consumption at full load
EXHAUST SYSTEM /
Maximum exhaust gas flow /
Max. exhaust gas temp. /
Maximum back pressure /
External diameter exhaust pipe /
ELECTRICAL SYSTEM /
Starter motor power /
Battery charging alternator cap. /
Cold start /
AIR FILTER Dry
Combustion air flow /
HEAT REJECTED AT FULL LOAD
To exhaust system /
To water and oil /
Radiated to room /
To charge cooler /
* Potenze dichiarate in accordo a ISO 3046-1
pag 1
01/2021
E
N
G
I
N
E
S
T
A
G
E
5