Product Card
MADE IN ITALY
language
Pag 3
CONTROLLER CHARACTERISTICS RGK420SA
Operating mode • OFF - ON - REMOTO
Display • Graphic back-light LCD display 52x35 mm
Buttons / controls • Key 3 positions
• START button
• N° 2 buttons for controller programming
Generator Measures
• Voltage : L1-L2-L3-N
• Current : I1
• Powers : kVA
• Frequency
Engine Measures • Engine temperature (optional)
• Oil pressure (optional)
• Fuel level
• Rpm meter
• Battery voltage
• Maintance
• Hours meter
Protections Generator • Short circuit
• Over-Undervoltage
• Over-Underfrequency
• Phase sequence
• Asymmetry
• Overpowering
Engine Protections • High engine temperature warning
• Low oil pressure warning
• Low fuel level warning
• High / Under battery voltage
• Battery charge alternator failure
• Start failure
• Stop failure
• Emergency stop
Features 5 languages dysplay: GB
- I - F - E - D
• Remote Start and Stop
• Pre-heating
• Fully programmable from the panel, PC, WI-FI
or NFC
• Manual operation with remote start (REM)
• IP 40 protection
• Operation temperature: -30°C / +70°C
Communication • Setup USB port
• CAN BUS interface (J1939 only)
09/2019
CONTROL PANEL
TS 600 EVO MULTI4
• Controller RGK420SA
• Emergency stop buttom
• Ground fault interruptor
• Output sockets CEE: 1x 400V 32A 3P+N+T AUS
2x230V 32A 2P+T AUS
• Siren
• Socket circuit breaker
• Remote control connector
• GOUGING socket
• Connection of wire feeder
ContRol PanEl
ContRol PanEl Multi4
CONTROLLER CHARACTERISTICS MULTI4
Rotary switch for welding process • Stick (SMAW)
• Stick contact
• Mig/Flux Cored (GMAW)
• Mig/Flux Cored contact
• Tig lift arc (GTAW)
• Tig pulse
Encoder for current - voltage
welding control
multifunctional encoder • Arc force control
• Hot start voltage setting
• Turn-o time arc control
• Switching frequency setting
2x Display (4 Digit)
• Current and voltage during the welding process
• DISPLAY 1: Set the welding current and the
voltage
• DISPLAY 2: Settings controlled by the multifun-
ction encoder
LED VRD • Show if VRD is enabled
LED A/V • Kind of value shown on display 1
LED % - s - Hz - V- A • Kind of value shown on display 2
SET Botton • Shows and saves the program
BOTTON
WS1 –WS2 –WS3
• Recall a welding program saved previously, up
to 3 programs can be stored for each welding
process
BOTTON
WS3
• Access to the secondary parameters for
welding
LED BOTTONS • Signal for storing and program recall