14 kVA Kohler Three Phase Multi Process DC Arc Welder Generator_Manual

21/04/21 C1SS0000_EN
M
34.2
EXTERNAL BOX POLARITY CHANGE CONNECTION
PL 400
REV.0-04/21
POLARITY SWITCH
POLARITY SWITCH
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
RCE-PL
BOX PL 400
35%
60%
100%
400
360
330
48 23
12,5
1~50/60 Hz U (V)2
IP
Kg
- Connect the welding cables according to the right polarity.
- The welding cables must have an adequate section for the current and the service factor X%. Refer to the DATA PLATE of the
PL 400 box
- Activate the polarity inversion by acting on the "POLARITY SWITCH" on the BOX PL 400.
- Polarity inversion can also be performed by remote control. Connect the RCE-PL remote control to the 10-pole connector on
the welding machine. The "POLARITY SWITCH" on the PL 400 BOX will be automatically disabled.
ATTENTION: only the RCE-PL remote control is suitable for this application.
- The polarity inversion is performed only when the machine is running.
- Do not perform polarity inversion during the welding phase.